MassiveOverkill
[H]ard|Gawd
- Joined
- Jul 8, 2005
- Messages
- 1,748
The HR01+ dimensions are L110 x W60 x H159.
There is roughy 12mm clearance between my power supply and the side of the heat sink. There is even less clearance between the 120x25mm fan and the modded hard drive rail. This leaves a heat sink that is 66mm wide at most with additional modding.
The Length is actually smaller than a 120mm fan and this leaves very little room for the SATA data/power cables even with my hard drive cage relocation mod.
To fit a TRUE, you would have to relocate your hard drives to the 5-1/4" bays or 3-1/2" bay, hope it clears your optical drive if you have one, and forego using your innermost RAM slots.
Looking at it now a Xigmatek Dark Knight will fit, but you would have to perform some nifty sata cable routing.
I forgot to add, this is with the RampageII Gene board. If you use another board, your results may vary as the CPU socket location may vary.
There is roughy 12mm clearance between my power supply and the side of the heat sink. There is even less clearance between the 120x25mm fan and the modded hard drive rail. This leaves a heat sink that is 66mm wide at most with additional modding.
The Length is actually smaller than a 120mm fan and this leaves very little room for the SATA data/power cables even with my hard drive cage relocation mod.
To fit a TRUE, you would have to relocate your hard drives to the 5-1/4" bays or 3-1/2" bay, hope it clears your optical drive if you have one, and forego using your innermost RAM slots.
Looking at it now a Xigmatek Dark Knight will fit, but you would have to perform some nifty sata cable routing.
I forgot to add, this is with the RampageII Gene board. If you use another board, your results may vary as the CPU socket location may vary.
Last edited: