Recent content by turok_t

Hi everyone, I managed to get a hold of Mayhem’s Inhibitor + and Hades + for my loop. On the bottle it says. On the bottle, the instructions are “Mix 1 drop to 1 Ltr then add 1 drop every 2 to 3 months as a top up.” However, on the website, the instructions are “Mix at a Ratio 0.05% e.g 0.5ml...

Yes! that is exactly what I see. How the biofilm got in is beyond me, probably was the distilled water that was used (even though i got it sealed) or the Dazmode coolant i used was ineffective (i heard feser one isn't that great).

Oh dont worry, ive taken it a part before and cleaned every tube, opened up every block and cleaned it too. Its just a hassle, but its not a problem. Im more worried about taking things apart and putting it together repeatedly which may cause fittings and orings to be loose which may increase...

do you have a brand for your antifreeze? how much anti-freeze did you mix with distilled water?

Any coolant you guys would recommend? or any DIY methods that are safe and doesnt cause more issues in your loop?

Whats disabled water? You mean distilled water?

Well, yes, obviously it has to be flushed and cleaned out... Anyone have any good recommendations of clear coolant that they have used?

Where would the dust/crud have come from? I inspected all the parts before installation and everything is new. The CPU/water blocks were completely spotless before installing and the rads were rinsed too. These spots tend to be growing more and more overtime, so i doubt its residual debris from...

Hey everyone, I had my loop for around 6 weeks now and all my parts are new including: CPU block, GPU block, pump, reservoir, radiators x2 and hard tubing. They are all brand new and never used. Given that my CPU and GPU block have acrylic tops, I can see that they were absolutely clean without...

The flow meter was not reading properly because the bubbles were obstructing its measure. As i continued to allow the system to bleed out the air bubbles with a lot of tilting, rocking and changing the pump RPM, the flow meter showed gradual increase in flow rate. Initially, the pump would be...

Thanks for all your comments guys! anyways, I fixed the issue. The flow meter is much more accurate now and increasing the pump RPM doesn't create bubbles from the impeller. All the air bubbles are gone and the pump is inaudible even at high RPMs.

Yeah my mobo has CPU_OPT which is meant to measure pump speed. On full speed, my pump sounds very loud and generates a lot of bubbles. It sounds like its in overdrive mode. Adjusting the speed to full speed in my BIOS sounds exactly like if i just use the molex connector. So i know it is indeed...

Hi everyone, here is an update on my build. Pump and reservoir has been installed back into my rig and I’m just leak testing everything. So far, there are no leaks, however, I’m wondering if my pump flow is being restricted. As you can see from the picture below, I have a sharp 90 degree angle...

I have a proper TV setup already, thank you. I can already watch something on my TV setup, which is my original question pertains to a desktop ultrawide monitor for watching movies.

Yes. it preserves most of the information, but where do you see that this information is related to picture quality and image? This can be data that may not affect picture quality.